Lexmark XM3150 - Scanner manual registration

Format fax storage
This setting enables you to format the non-volatile storage used for storing faxes.
To change this setting:
1 Select Format Fax Storage from the Configuration Menu.
Note: If an advanced password has been established, then you must enter this password to change the
setting. If no advanced password exists, then you can establish one by using the keyboard that appears
on the LCD.
2 Select Submit to save the change.
3 Select Back to cancel and return to the Configuration Menu. Formatting Fax Flash DO NOT POWER
OFF appears on the display while the format operation is active.
ADF edge erase
This menu item sets the size, in millimeters, of the no-print area around an ADF scan job. All copy jobs have a
minimum of a two millimeter border. Copy jobs will use the setting or two millimeters, whichever is larger.
To adjust the ADF edge erase setting, perform the following steps:
1 Select ADF Edge Erase from the
Configuration
Menu. [setting's current value] displays.
2 Select minus to decrease the setting’s value or plus to increase the setting’s value.
3 Select Submit to save the change.
4 Select Back to cancel and return to the Configuration Menu.
Flatbed edge erase
This menu item sets the size, in millimeters, of the no print area around a flatbed scan job. Copy jobs will use
the setting or two millimeters, whichever is larger.
To adjust the flatbed edge erase setting, perform the following steps:
1 Select FB Edge Erase from the
Configuration
Menu. [setting's current value] displays.
2 Select minus to decrease the setting’s value or plus to increase the setting’s value.
3 Select Submit to save the change.
4 Select Back to cancel and return to the Configuration Menu.
Scanner manual registration
This item is used to manually register the flatbed and ADF on the MFP scanner unit. Registration should be
performed whenever the ADF unit, flatbed unit, or controller card are replaced.
To manually register a Duplex ADF, perform the following steps:
1 In the
Configuration
Menu, scroll to the Scanner Manual Registration menu item.
2 Select Scanner Manual Registration.
3 Select Print Quick Test Page.
7016
Service menus
227