To reset the maintenance counter:
1 POR into the Configuration menu, and navigate to Reset Maintenance Counter.
2 Depending on the printer model, press OK or touch to reset the counter, or press X to exit without
resetting the counter.
Once initiated, the operation cannot be canceled.
Lubrication specification
Lubricate only when the parts are replaced or if necessary, not on a scheduled basis. The use of lubricants
other than those specified in this service manual may cause premature failure. Some unauthorized lubricants
may chemically attack polycarbonate parts. Use Grease P/N 99A0394 Nyogel 744.
Cleaning the printer
Cleaning the printer
Note: You may need to perform this task after every few months.
Warning—Potential Damage: Damage to the printer caused by improper handling is not covered by the
printer warranty.
1 Make sure that the printer is turned o and unplugged from the electrical outlet.
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock when cleaning the exterior of the
printer, unplug the power cord from the electrical outlet and disconnect all cables from the printer
before proceeding.
2 Remove paper from the standard bin and multipurpose feeder.
3 Remove any dust, lint, and pieces of paper around the printer using a soft brush or vacuum.
4 Dampen a clean, lint-free cloth with water, and use it to wipe the outside of the printer.
Warning—Potential Damage: Do not use household cleaners or detergents to prevent damage to the
exterior of the printer.
5 Make sure all areas of the printer are dry before sending a new print job.
7016
Maintenance
441
To Next Page
Loading...
