3 Remove the rear door and cover. See “Rear exit door removal” on page 342 and “Rear cover removal”
on page 343.
4 Remove the power supply. See “Power supply removal” on page 323.
5 Remove the power supply shield. See “Power supply shield removal” on page 323.
6 Remove the duplex. See “Duplex removal” on page 324.
7 Disconnect the cable JDUPPI1 from the controller board.
8 Remove the two screws (A), and cut the cable near the frame to detach the sensors.
9 Remove the other half of the cable from the printer.
7016
Repair information
326
To Next Page
Loading...
