CHAPTER 1 : BASIC NOTIONS 1 - 7
TRYTON 112 CNC
C Do not place the machine in a damp area and make sure that water or oil does not come
into contact with the electrical equipment.
C Do not open the clamping device (collet or chuck) of the lathe manually when the bar
feeder is in automatic mode (Interface).
C Each time the diameter is changed, also adapt spindle reduction tube. The use of
spindle reduction tubes is highly recommended for machining bars with diameters
smaller than the maximum capacity of the spindle.
C Do not attempt to recharge the batteries of the PLC.
C For the use and maintenance of the bar feeder, use only parts provided by or
recommended by LNS.
C If it is necessary to move the bar feeder once it has been originally installed, do not
reinstall it before first contacting LNS or its local representative.
C LNS disclaim all responsibility for possible accidents or property damage caused when
safety instructions are not followed.
To Next Page
Loading...
