LNS TRYTON 112 - Various Functions and Parameters; Service Parameters

8 - 18 CHAPTER 8 : OPERATION
TRYTON 112 CNC
Note :
To validate a
new
parameter or
a new value,
keep
[ENTER]
pressed until
the icon
disappears
5.2.3 Various functions and parameters
5.2.3.1 Choice of language
This parameter allows to adapt the language in which the messages will appear,
depending on the country of destination of the bar feed system.
5.2.3.2 Automatic cycle (Dry-Run) emulation
This function allows the use the lathe (in the production cycle) without the bar feed
system (chuck work, pre-heating of the lathe, etc.).
In order to activate this parameter, the pusher and the movable vise must be in rear
position and the main cover must be closed.
5.2.4 Service parameter
The service parameters allow to configure the bar feed system in its environment and to
adapt the interface connected to the lathe.
These parameters are protected with a password, because only LNS (or certified)
technician is authorized to modify them.