1 - 6 CHAPTER 1 : BASIC NOTIONS
TRYTON 112 CNC
4. SAFETY INSTRUCTIONS
C Do not handle the equipment without having knowledge of the safety instructions and
the instructions for use. Safety instructions for the bar feed system, as well as the CNC
lathe, must be strictly observed.
C Non-qualified personnel, children, and persons under the influence of alcohol or
medication should not handle the equipment.
C Loose garments, long hair and jewelry can be dangerous.
C Do not remove any covers while the bar feeder or the machine is under electrical
power.
C Do not conduct any maintenance operations during the automatic cycle.
C Do not grasp moving or rotating objects, or nearby elements.
C If certain safety shields or safety covers are removed to conduct maintenance, they
must be reinstalled as soon as the maintenance work is completed.
C No servicing should be carried out on the interface or inside the electrical cabinet while
the bar feeder or the lathe is under electrical power.
C It is strictly prohibited to jump wire or remove circuit breakers, main switches, and
especially safety switches.
C To avoid any harm to persons, or damage to components, use only the indicated points
for lifting and moving the bar feeder system. No one should be near the hanging load,
or within the operating range of the overhead hoist/crane, forklift, or any other means
used for lifting and transportation. Do not knock the bar feeder while moving it as this
could damage it.
C Do not move the bar feeder while it is electrically powered on.
C The work area surrounding the bar feed system should always be clear of objects and
well lit. The presence of oil on the ground could cause falls; it is important to maintain
the floor clean on a regular basis.
To Next Page
Loading...
