CHAPTER 8 : OPERATION 8 - 9
TRYTON 112 CNC
4. AUTOMATIC SEQUENCE
Please read the safety instructions provided at the beginning of this manual
before handling the following devices.
4.1 Description
The amount of time the bar-feeder can run unattended will depend directly on the
frequency with which the operator fills the barrel. This operation can be effected during
the production cycle.
Each time the automatic sequence of the bar feed system needs to be started up, it is
advisable to check the following elements :
C The bars must be butted against the rear stop in the barrel.
C The collet of the bar feed system must correspond to the diameter of the bar.
C The pushing torque must correspond to the material to be loaded
C The outboard support (option) must be correctly adjusted (opening and closing)
and its elements must be adapted to the shape of the material.
C On the lathe, the clamping device must correspond to the material to be loaded.
To Next Page
Loading...
