4 - 2 CHAPTER 4: ELECTRICS
TRYTON 112 CNC
1. ELECTRICAL EQUIPMENT
Please read the safety instructions provided at the beginning of this manual
before handling the following devices.
Particular attention should be given to the handling of electrical elements
because of risks of electrocution. In case of possible electrical malfunctions, it
is advisable to contact LNS or their local representative.
1.1 Description
The electrical parts of the bar feed system, as well as the diagrams representing them,
conform to the ISO/IEC 204-1, 617 international electrical codes.
This chapter contains all of the elements regarding the electrical circuit of the bar feed
system. The electrical parts, and groups, which may require a setting, at some time or other,
are described herein in detail.
Whenever possible, the article numbers of the elements are shown in tables below each
drawing. When a group of elements is indicated, look for the element and then write down
the ordering number of the desired element.
To Next Page
Loading...
