CHAPTER 8 : OPERATION 8 - 5
TRYTON 112 CNC
1.2 Function keys f1 - f4
These keys are located right below the display. The functions attributed to them are
indicated on the display by icons.
As the operator advances in the handling, the functions of the keys are automatically
reattributed.
The risk of error in handling is therefore virtually reduced given that the proposed
functions always correspond to the circumstance and availability of the bar feed system.
1.3 Numerical keys 0-9
The numerical keys go from 0 to 9, making it possible to introduce values such as the
diameter of a bar, the length of a part, etc.
When a list of parameters is submitted, the numerical keys make it possible to select
them (see further in the manual).
The blue keys have no functions on this type of bar feed system.
1.4 Emergency stop switch
When a dangerous situation arises, pressing the emergency stop switch interrupts
immediately all bar feed system and lathe functions (if interface is wired accordingly).
To cancel the alarm, release the switch by rotating its red knob counter-clockwise.
To Next Page
Loading...
