LNS TRYTON 112 - Command Keys (Stop, Clear, Help, Menu)

8 - 6 CHAPTER 8 : OPERATION
TRYTON 112 CNC
1.5 Command keys
a) STOP
The STOP key allows interrupting the sequence under way.
Important: the automatic cycle of the lathe must first be interrupted.
By pressing the STOP key, allows to exit the setting mode, regardless of the level
reached, and to return to the work screen.
b) CLEAR
The CLEAR key allows canceling a value input by error.
c) HELP
The HELP key allows obtaining further information.
d) MENU
The MENU key allows at all times, to reach the setting functions of the bar feed system.
The functions are shown in section 5.
By pressing down on the MENU key, it is possible to remove the setting mode,
regardless of the level one has reached, and to return to the work screen.