TRYTON 112 CNC
INTRODUCTION
The TRYTON 112 bar loader is a worthy successor to the Tryton SST, which became a
reference in its category and from which it has inherited the main qualities.
While integrating the latest technological innovations, it offers users a range of surprising
functions, while at the same time remaining simple to use and remarkably reliable.
The ergonomic and user-friendly remote control with a clear, integrated display facilitates
the handling of the magazine. Depending on the sequence under way, the magazine offers
the operator only the available functions, thus avoiding any improper handling and reducing
the time required to access the desired functions.
The hydraulic oil, contained in a tank, is injected into the barrel at a constant pressure which
can be adjusted according to the type of material to be loaded.
This oil pressure, on the one hand, provides the force necessary to push the piston and, on
the other, permits a constant flow of oil from the compression chamber, through the piston,
and into the guidance tube where it hydrodynamically supports the rotating bar.
So there is no metal-on-metal friction. Noise and vibrations are eliminated at source.
The system can be setup for another range of diameters by a few simple operations (not
counting the start-up of the lathe).
According to the configuration chosen, the TRYTON 112 hydraulic bar-feeder can cover a
range of diameters from 1 to 12.7 mm.
To Next Page
Loading...
