LNS TRYTON 112 - Parameters Related to Start-Up

8 - 16 CHAPTER 8 : OPERATION
TRYTON 112 CNC
Note :
To validate a
new
parameter or
a new value,
keep
[ENTER]
pressed until
the icon
disappears
5.2.1 Parameters related to start-up
The manipulations, adaptations, and settings, specific to the machining of a part, and
which must be made to the bar feed system are part of the start-up.
The mechanical settings which must performed on the bar feed system are presented in
the Start-up manual.
5.2.1.1 Collet changeover
This parameter is for replacing the collet when changing diameter. See Start-up Manual.
5.2.1.2 Diameter changeover (Hybrid option)
With this parameter, the reduction tube can be replaced and the barrel indexed when
changing diameter. See Start-up Manual.
5.2.1.3 Clamping device: By pulling / By pushing (option)
(Available depending on the settings of the service parameters)
The interface signal is reversed depending on whether the clamping device functions by
pushing or by pulling. It is therefore essential to know the operation of the clamping
device, without this, the feeding process cannot be done correctly.