3. Installation and Wiring
3-13
3.4 Control Board and Terminal
3.4.1 Control board Jumper description
z Control board Jumper description according to S/W version
Set jumper of control board as following, if it is not set rightly, it may result in misworking
(S/W version can be verified in display group of Function code list
.)
1) Before S/W V2.00 (V1.XX ~ V1.93)
Set JP1 to OLD in Control board
2) After S/W V2.00 (V2.00 ~ )
Set JP1 to NEW in Control board.(Factory default)
Note) The products which released after 2007 are being set up to “NEW”
z iV5 Control Board (5.5 ~ 375kW Class)
JP1
OLD :
NEW :
To Next Page
Loading...
