4. Trial Operation
4-4
4.4 Data Groups
SV-iV5 series inverters use LCD keypad for user’s convenience. Data groups are divided into 12 groups for
easy access depending on the inverter application.
Name
LCD keypad
(on the upper
left)
Description
Display group DIS
Motor speed, Motor control mode, Generatin
torque, Output
current, User selection display, Process PID output/reference/feed-
back value, Fault display, User group display setting and so on.
Digital I/O group DIO Digital input parameters, Digital output parameters and so on.
Parameter group PAR
Parameter initialization, Parameter read / write / lock /password,
Motor related constants, Auto-tuning and so on.
Function group FUN
Operating frequency, Operation mode, Stop mode, Acceleration
/deceleration time and pattern, Carrier frequency, Electronic thermal
selection and so on.
Control group CON
Control mode, ASR PI gain, Process PID gain, Draw control setting,
Droop control related constants, Torque control related constants,
V/F control related constants and so on.
Exterior group EXT
1)
It is displayed when Communication option board is installed.
Communication setting parameter and so on.
Analog I/O group AIO Analog Input or Output Parameter and so on.
User group USR User macro function, macro function save, macro function recall
2
nd
function group 2nd
2
nd
motor control mode, 2
nd
motor accel./decel.time, 2
nd
motor
parameters and so on.
Elevator group E/L
1)
It is displayed when EL_I/O option board is installed, Elevator
operation function setting parameter and so on.
Synchronous
group
SYNC
1)
It is displayed when SYNC_I/O option board is installed.
Synchronous operation function setting parameter and so on.
WEB group WEB
Diameter and Tension control setting parameter while WEB
control.
1) It is displayed when option board is installed, Refer to the option manual for more details
Refer to Chapter 6. Function Description for more details.
Refer to the description of Chap. 7 for more information about WEB group.
To Next Page
Loading...
