LS Industrial Systems SV-iV5 Series - Chapter 7 WEB Control Application; Changing to WEB Control Mode

7. WEB Control Application
7-1
Chapter 7 WEB Control Application
7.1 Change into WEB control mode
LCD loader display is indicated up to 32 digits in English letters and Arabic numerals, allowing you to directly check a
variety of settings on screen.
Shown below are the appearance of LCD loader and the functions of each part.
When setting control (CON) group CON_02 (Application) to “WEB Control”, LCD loader home screen is changed into
web control mode as shown in the following figure. For the function of each key of the loader, please refer to ‘Loader’
in 4.1, Chapter 4.
7.1.1 Method of Changing into Web Control Mode
CON▶Application
02 General Vect
CON▶ Application
02 General Vect ■
CON▶ Application
02 WEB Control ■
CON▶ Application
02 WEB Control
0
.0rpm WEB
Tq
0.0% 0.0A
Move to Application Mode of Control (CON) Group
Universal Vector Application Mode
–
Cursor appears (■)
Change into WEB control mode using [▲(Up)] key.
Set to WEB control mode pressing [ENT] key..