LS Industrial Systems SV-iV5 Series - Encoder Wiring and Switch Setting Method (+5 V Line Drive)

3. Installation and Wiring
3-19
3.4.6 Encodder
wiring and switch setting method(+15V Complementary / Open Collector Type)
Shield Wire
3.4.7 Encoder wiring and switch setting method (+5V Line Drive) ※ Jumper set as default
Shield Wire
CAUTION
z NEVER change the switch setting for Encoder Type during inverter run. Otherwise, it may
cause inverter trip, adversely affecting the entire system.
Therefore, verify the switch is correctly set before operation.
+5V Line Drive (LD)
+15V Open Colletcor (OC)