LS Industrial Systems SV-iV5 Series - Analog Input Jumper Setting (Voltage;Current;Motor NTC;PTC Input) and PNP;NPN Input Mode Switch Setting

3. Installation and Wiring
3-20
3.4.8 Analog input jumper setting (Voltage/Current/Motor NTC/PTC Input) and PNP/NPN
input mode switch setting
※ Jumper set as default : Voltage Input (Left)
※ Factory Default Jumper Setting: NPN (down side)
z Guaranteed PNP type input voltage (external DC 24V): On voltage (DC 19~25.2 V)/ Off voltage (DC
7V or less)
AI1, AI2
Voltage input : Left
Current input : Right
AI3 Switch
Voltage input : Left
Motor NTC/PTC input : Right
JP4
PNP :
NPN :
DC 24 V
P1
CM
CM
JP4
NPNSW JP4
R
(Inside of inverter)
P1
CM
CM
DC24V
(Inside of inverter)
R
DC 24 V
PNP SW JP4
In case of using internal DC 24V [NPN]
In case of using external DC 24V [PNP]