LS Industrial Systems SV-iV5 Series - Dis_06(User Group Display Selection)

6. Function Description
6-4
No
Trip information LCD display
No
Trip information LCD display
1 Overcurrent in Phase U OC–U 14 Electronic thermal E-Thermal
2 Overcurrent in Phase V OC–V 15 Overload trip Over Load
3 Overcurrent in Phase W OC–W 16 External trip B Ext-B Trip
4 Fuse Open Fuse Open 17 Communication Error COM Error
5 Overvoltage Over Voltage 18 Inverter overload Inv OLT
6 IGBT short in phase U Arm Short–U 19 Motor overheat MotOver Heat
7 IGBT short in phase V Arm Short–V 20 Inverter thermal open InvThem OP
8 IGBT short in phase W Arm Short–W 21 Motor thermal error MotThem Err
9
IGBTshot in pahse DB
*1)
Arm Short–DB 22 Motor over speed Over Speed
10 Encorder Error Encoder Err 23 H/W Error HW-Diag
11 Low voltage Low Voltage 24 Inverter over heat
*2)
OHD Open
12 Ground fault Ground Fault 25 FAN faulty
*2)
FAN LOCK
※
Note :
When multiple faults occur at the same time, the MOST CRITICAL fault will be displayed and the rest of
others can be inferred from the value using [PROG], [
▲
(Up)] / [
▼
(Down)] keys .
*1) Applicable only to SV110~220V5.
*2) Applicable only to SV2800~3750V5.
6.1.5 DIS_06(User group display selection)
User can make “User group” by collecting frequently used codes. In DIS_06, user can set whether User group is
displayed or not in three selections.
Code LCD display Parameter name Description
Not Used User group not displayed
Dis+Usr Grp
Only Display + User group displayed. The
rest of groups are not displayed. If you
want to display the rest, move to other
group in Jump code or change the
selection.
DIS_06 Usr Grp Disp
User group display
selection
Display ALL
Display all groups including User group.
But, 2nd group is displayed only when 2
nd
group is defined. EXT group is displayed
when Option board is installed.