6. Function Description
6-80
Multi-function analog output setting types and range are as below
Setting Description Output signal level
AiX Value Analog input value +10 V: 10V, 20mA
PreRamp Ref Pre Ramp Reference +10 V: Max Speed
PostRamp Ref Post ramp reference +10 V: Max Speed
ASR Inp Ref ASR Input Reference +10 V: Max Speed
Motor Speed Motor Rotating Speed +10 V: Max Speed
Speed Dev Speed Deviation +10 V: Rated slip * 2
ASR Out ASR Output +10 V: 250%
Torque Bias Torque bias +6 V: 150%
PosTrq Limit Positive Trq Limit 10V: 250%
NegTrq Limit Negative Trq Limit 10V: 250%
RegTrq Limit Regeneration Trq Limit 10V: 250%
Torque Ref Torque Reference +10 V: 250%
IqeRef Torque current ref. +10V: 250% of rated torque current
Iqe Torque current +10V: 250% of rated torque current
Flux Ref Flux reference 10V: Flux rating * 2
IdeRef Flux Current ref. +10V: Rated flux current * 2
Ide Flux Current +10V: Rated flux current * 2
ACR_Q Out ACR output of axis Q +10 V: 300/600
ACR_D Out ACR output of axis D +10 V: 300/600
VdeRef Voltage reference of axis D +10 V: 300/600
VqeRef Voltage reference of axis Q +10 V: 300/600
Out Amps RMS Output current 10 V: Rated current * 2
Out Volt RMS Output voltage +10 V : 300/600
Power Output power +10 V: Rated output * 2
DC Bus Volt DC LINK voltage 10 V: 500/1000V
Proc PI Ref Process PI reference +10 V: Rating
Proc PI FB Process PI Feedback +10 V: Rating
Proc PI Out Process PI output +10 V: Rating
Mot NTC Temp Motor temperature +10V : 150°C
Mot PTC Temp Motor temperature +10V : 150°C
Inv Temp Inverter temperature +10 V: 100°C
Inv i2t Inverter i2t 10 V: 150%
To Next Page
Loading...
