LS Industrial Systems SV-iV5 Series - Page 70

6. Function Description
6-2
Code Parameter name LCD display Unit Description
Regeneration Trq Limit Reg Trq Limit % Regeneration torque limit to rated torque
Torque Reference Torque Ref % Torque reference to rated torque
Torque current ref. IqeRef % Torque current reference to rated torque current
Torque current Iqe % Actual torque current to rated torque current
Flux reference Flux Ref % Flux reference to the rated flux
Flux Current ref. IdeRef % Flux current reference to rated flux current
Flux Current Ide % Actual flux current to rated flux current
ACR output of axis Q ACR_Q Out V ACR output value of axis Q
ACR output of axis D ACR_D Out V ACR output value of axis D
Voltage reference of
axis D
VdeRef V Voltage reference value of axis D
Voltage reference of
axis Q
VqeRef V Voltage reference value of Q axis Q
Output current Out Amps RMS A Inverter output current (rms)
Output voltage Out Volt RMS V Inverter output voltage (rms)
Output power Power kW Motor output power
DC LINK voltage DC Bus Volt V Inverter DC link voltage
Process PI reference Proc PI Ref % Reference value of Process PID routine
Process PI Feedback Proc PI F/B % Feedback value of Process PID routine
Process PI output Proc PI Out % Output value of Process PID routine
Motor temperature
NTC
Mot Temp NTC deg
Temp displayed when mot temp sensor is NTC. 25
℃
displayed when temp sensor is not provided with the
motor.
Motor temperature
PTC
Mot Temp PTC deg
Temp displayed when mot temp sensor is PTC. 25
℃
displayed when temp sensor is not provided with the
motor.
Inverter temperature Inv Temp deg Inverter Heatsink temp displayed
Inverter i2t Inv i
2
t %
Inverter overload capability displayed. In the case
Overload capability is 150% for 1 min, i
2
t becomes
100% when 150% of rated current is flowing for 1
min.
MOP output MP Output %
Set value displayed when operation is done by
potentiometer on terminal input.
Control mode Ctrl Mode Selected control mode displayed
Software version S/W Version S/W version displayed
Running time Run Time Inverter running time displayed after Power On
ON/OFF status of Input terminal displayed
(0: OFF, 1: ON)
FX RX BX P1 P2 P3 P4 P5 P6 P7
Input terminal status Terminal In
0 :
OFF
1 :
ON
0/1 0/1 0/1 0/1 0/1 0/1 0/1 0/1 0/1 0/1
ON/OFF status of open collector output, fault relay
and contact output.
(0: OFF, 1: ON)
AX1 AX2 OC1 NC NC
30A
(30B)
Output terminal status Terminal Out
0 : OFF
1 : ON
0/1 0/1 0/1 0 0 0/1
DIS_01
~
DIS_03
Running status Run Status Operating status displayed
*1) In the case of using EXTN_I/O, it will be displayed up to Ai5.