Maintenance...Messages
5-145
LTO
0x12 Incompatible edger
configuration.
Drilling finishing not
allowed.
The job you have loaded calls
for Drilling finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.
Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Drilling finishing.
Load the job again.
0x13 Incompatible edger
configuration.
Grooving/drilling finishing
not allowed.
The job you have loaded calls
for Grooving/Drilling finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.
Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Grooving/Drilling fi-
nishing.
Load the job again.
0x14 Incompatible edger
configuration.
Automatic Bevel sub-fi-
nishing not allowed.
The job you have loaded calls
for Automatic Bevel sub-
finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.
Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Automatic bevel sub-
finishing.
Load the job again.
0x15 Incompatible edger
configuration.
Bevel curve sub-finishing
not allowed.
The job you have loaded calls
for basic Bevel sub-finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.
Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select basic Bevel sub-finishing.
Load the job again.
0x16 Incompatible edger
configuration.
Bevel distance (in mm) sub-
finishing not allowed.
The job you have loaded calls
for Bevel distance (in mm) sub-
finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.
Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Bevel distance (in mm)
sub-finishing.
Load the job again.
0x17 Incompatible edger
configuration.
Percent bevel sub-finishing
not allowed.
The job you have loaded calls
for Percent bevel sub-finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.
Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Percent bevel sub-
finishing.
Load the job again.
0x18 Incompatible edger
configuration.
Manual bevel sub-finishing
not allowed.
The job you have loaded calls
for Manual bevel sub-finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.
Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Manual bevel sub-
finishing.
Load the job again.
# Message title
Condition(s) for
display
Action(s)
To Next Page
