Maintenance...Messages
5-147
LTO
0x20 Incompatible edger
configuration.
Drilling parallel to clamp
shaft not allowed.
The job you have loaded calls
for Drilling parallel to clamp
shaft.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.
Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Drilling parallel to clamp
shaft.
Load the job again.
0x21 Incompatible edger
configuration.
Front safety-bevel not
allowed.
The job you have loaded calls
for front safety-bevel.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.
Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Front safety-bevel para-
meter.
Load the job again.
0x22 Incompatible edger
configuration.
Rear safety-bevel not al-
lowed.
The job you have loaded calls
for rear safety-bevel.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.
Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Rear safety-bevel para-
meter.
Load the job again.
0x23 Incompatible edger
configuration.
Front and rear safety-bevel
not allowed.
The job you have loaded calls
for front and rear safety-bevels.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.
Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select front and rear safety-be-
vel parameter.
Load the job again.
0x24 Incompatible edger
configuration.
Lens without safety-bevel
not allowed.
The job you have loaded has the
No safety-bevel parameter.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.
Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select the No safety-bevel para-
meter.
Load the job again.
0x25 Incompatible edger
configuration.
Safety-bevel to be defined
not allowed.
The job you have loaded has the
parameter Safety-bevel to be
defined.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.
Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select the Safety-bevel to be de-
fined parameter.
Load the job again.
0x26 Retouch impossible on dril-
led or grooved lens.
You wish to undertake a retouch
on a lens which has been drilled
or grooved. This operation is im-
possible on a lens with these
finishes.
Carry out the lens size adjust-
ment procedure. Fit a new lens
and enter a negative oversize
value.
0x2B Wrong job received. Problems
of communication with
the server have been detected.
Load another job number.
# Message title
Condition(s) for
display
Action(s)
To Next Page
