LX8000 version 0.96 April 2008
Page 46 of 85
Using UP/DOWN key pilot may select between options.
Button functions or remote menu will disappear automatically after 10 seconds if
no further action is taken.
In airport mode following selections are available:
• Mc/Bal will set MacCready, ballast and bugs, See chapter 5.5.5.2 for more details.
• Select option is used to select airport for new navigational target
• Map item is used to quickly change and modify map parameters
• Rot.FAI will rotate FAI area, if it is enabled. If it is not enabled, this option is not shown.
• Wind will open dialog, where wind changes with altitude are shown, wind can set and
methods for wind calculation are shown.
• Airspace shows list of airspace zones in vicinity of our position
• Event is used to log an event. Recording rate will be increased to 1 second for one
minute. A message “Event marked” will be shown on screen.
• Off will switch of instrument. Message LX8000 switching off will be displayed.
LX8000 can also be powered off, if upper left button is pressed for long time, until
message “switching off” is shown.
5.5.5.1 Select an airport
Selecting airport is very straightforward. Enter first letter of airport name using bottom-right
knob. Helper will show first airport, that matches this letter and next few airports will be
displayed in lower part of screen.
To Next Page
Loading...
Need help?
General
