LX8000 version 0.96 April 2008
Page 81 of 85
9.2.4 Adjusting the compass module
The compensation of the compass is done in the setup/hardware/compass
1. Orientate the glider to 360°. N label will be automatically focused
2. Stabilize reading and press SET to save correction for this direction
3. Rotate glider to next direction 45°, focus on label will move to NE
4. Stabilize reading and press SET to save correction for this direction
5. Repeat procedure for the remaining directions
To Next Page
Loading...
Need help?
General
