LX8000 version 0.96 April 2008
Page 5 of 85
5.7.6 Loading task 56
5.7.7 Moving task point 57
6 Variometer and Altimeter 58
6.1 Smart Vario description 58
6.2 Altimeter 59
6.2.1 IGC barogram recalibration procedure 59
6.3 Speed command 59
6.4 Final glide calculation 59
7 Flying with LX8000 60
7.1 On the ground 60
7.1.1 Power on procedure 60
7.1.2 Profile selection 60
7.1.3 Set elevation and QNH 60
7.1.4 Preflight check 61
7.1.5 Preparing a task 61
7.1.5.1 Assigned Area Tasks (AAT) 62
7.2 Performing the flight 64
7.2.1 Starting a task 64
7.2.2 Restarting task 64
7.2.3 Over turnpoint 65
7.2.4 Entering assigned area 65
7.2.5 Moving point inside assigned area 65
7.2.6 Task finish 65
7.3 Procedure after landing 66
8 Installation 67
8.1 Mounting LX8000 68
8.2 Installation of options 68
8.3 Ports and Wiring 70
9 Options 72
9.1 Flarm option 72
9.1.1 Configuration 72
9.1.1.1 Flarm external LED display 72
9.1.1.2 LX Flarm graphic display 74
9.1.1.3 LX Flarm display 57 mm 74
9.1.2 Installation 74
9.1.3 Functional check after installation 75
9.1.4 Error messages 76
9.1.5 Flarm traffic information on moving map 76
9.1.6 Flarm update procedure 76
9.1.7 Uploading obstacles 77
9.2 Compass Module 79
9.2.1 General 79
9.2.2 Installation of the compass module 80
9.2.2.1 Where to install 80
9.2.3 First test after installation 80
9.2.4 Adjusting the compass module 81
9.2.5 Final check 82
9.2.6 Input of local magnetic variation 82
9.3 LX 8000 Remote control 82
9.3.1 Stick handle with keys 83
9.4 Secondary vario indicators 83
10 Revision history 84
To Next Page
Loading...
Need help?
General
