Starting/switching off the engine – for crane operation
10.4 Air intake inhibitor
Operating Manual GMK6300L 3 112 xxx en 10 - 23
xx.xx.xxxx
10.4 Air intake inhibitor
If the air intake inhibitor is triggered, a flap in the air intake line will close
and the engine will stop running. The air intake inhibitor is triggered,
– if an emergency stop switch is actuated or
– when the maximum permissible engine speed is exceeded. In this case,
the symbol (1) will turn red in the
Warning submenu. The symbol stays red
until the ignition has been turned off.
The engine can be restarted only after the air intake inhibitor has been
released.
Releasing the air
intake inhibitor
The following requirements must be met in order to release the air intake
inhibitor:
– The ignition must be switched off.
– The emergency stop switch must be reset.
The indicator (2) shows the current state of the
air intake inhibitor (1).
(A) – The indicator (2) is in the
closed position.
(B) – Turn the indicator (2) clockwise until it
engages in the
released position.
You can close the air intake inhibitor manually
with the lever (3).
To Next Page
Loading...
