Rigging work
12.5 Starting the engine for driving for rigging work
Operating Manual GMK6300L 3 112 xxx en 12 - 23
xx.xx.xxxx
12.5 Starting the engine for driving for rigging work
The engine for driving must be running for rigging work, e.g., to move the
outriggers. You can start the engine for driving:
– From the crane cab,
– From the control units of the outriggers.
H
You can generally start the engine only if a bridging plug is inserted in all
sockets not required.
12.5.1 Starting/turning off the engine from the crane cab
Prerequisites The following requirements must be met before you can start the engine for
driving from the driver's cab:
– The hand-held control must be disconnected and bridging plugs plugged
into all the sockets.
– The carrier ignition is switched off and the ignition key is removed. The
lamp (1) in the crane cab has gone out.
– The superstructure ignition has been switched on for approx. 30 seconds.
The engine for crane operation can be switched on or off.
Starting the
engine
All activities and checks required to start the engine must be carried out
before starting the engine;
à p. 4 - 1.
• In the main menu press button (1) once.
The
Outriggers submenu opens.
s
To Next Page
Loading...
