Page 87
Operation and Maintenance
capaNCDT 6200
9. Operation and Maintenance
Please take care of the following:
Make sure that the sensor surface is always clean.
Switch off the power supply before cleaning.
Clean with a damp cloth; then rub the sensor surface dry.
Changing the target or very long operating times can lead to slight reductions in the operating quality (long
term errors). These can be eliminated by recalibration.
Disconnect the power supply before touching the sensor surface.
> Static discharge
> Danger of injury
If the controller, the sensor or the sensor cable is
defective, please send us the affected parts for
repair or exchange. If the cause of a fault cannot
be clearly identified, please send us the entire
measuring system to:
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Koenigbacher Str. 15
94496 Ortenburg / Germany
Tel. +49 (0) 8542 / 168-0
Fax +49 (0) 8542 / 168-90
info@micro-epsilon.com
www.micro-epsilon.com
To Next Page
Loading...
Need help?
General
