Page 51
Ethernet Interface
capaNCDT 6200
6. Ethernet Interface
You will achieve especially high resolutions if you readout the measurements in digital form via the Ethernet
interface.
For that purpose, use the web interface or a special program. MICRO-EPSILON supports you by the driver
MEDAQLib, containing all commands for capaNCDT 6200.
You can find the current driver routine including documents at:
www.micro-epsilon.com/download
www.micro-epsilon.com/download/software/MEDAQLib.zip
6.1 Hardware, Interface
The data logging of all channels is synchronous.
Connect the capaNCDT 6200 to an available Ethernet interface at the PC. Use a crossover cable.
For a connection with the capaNCDT 6200 you will require a defined IP address of the network interface card
inside the PC. Go to Control Panel\Network Connections. Set up, if applicable, a new LAN connec-
tion. For more information, contact your network administrator.
Fig. 23 LAN connection of a PC
To Next Page
Loading...
Need help?
General
