Microplex SOLID 50 A3 - 3 - Page 11

Introduction 11
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID 50 A3 - 3 Edition 2.1
This MICROPLEX product and its consumables are designed and
tested according to strict safety standards.
By heeding the following instructions, the user is ensured safe
operations:
- Please make sure your electricity source is properly grounded.
- Install the device on solid and level ground.
- Only trained staff are authorized to transport the equipment.
- Only use consumables which are specially developed for this
device.
- Using improper consumables may cause a reduction of
output quality or damage to the device.
- Ensure no liquids get on or into the device.
- Do not remove any cover or safety device fastened by screws.
- Do not bridge a safety device.
- Do not push anything into the ventilation apertures.
- Never carry out installations, cleanings, or maintenance operations
which are not described in this manual. These operations should
only be done by MICROPLEX authorized service personnel.