MIMAKI CJV150-107 - Page 247

© 2014 MIMAKI ENGINEERING CO.,LTD.
6.6.2 P.3
6.6.2 Pen Assy, LED Pointer, Marl Assy.
1
2
3
4
5
6
7
8
7. Remove the Pen encoder sensor from L sensor BKT 2. (Screw
x2)
8. Remove the PR sensor. (Screw x1)
 Mark sensor Assy. (sensor and LED pointer)
9. Remove the mark sensor assy. together with the T sensor BKT
from the rear of the printer. (Screw x2)
10. Remove the T sensor cover (screw x1) and then mark sensor
assy.
11. Reverse the disassembly procedure for reassembly.
L sensor BKTC2
Pen encoder sensor
PR sensor
T Sensor BKT
T Sensor Cover
Mark Sensor Assy
In reassembly, pay attention to harness treatment.
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Cutting-related Parts > Pen Assy, LED Pointer, Marl
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver. Remark
1.0
Rev.