5-16
Message Cause Solution
An error occurred in the main PCB
3.3VB power supply.
• Turn off the power to the machine and
turn it on after a while.
If the same error message appears
again, contact your local distributor to call
for service.
An error occurred in the main PCB
VCORE power supply.
An error occurred in the main PCB 1.5V
power supply.
An error occurred in the main PCB 12V
power supply.
COM driver becomes the high tempera-
ture.
New Print Head was recognized.
The main PCB Q6 is disabled (short
mode).
An error is detected on the waveform
printed on.
Abnormality of the flushing control.
Abnormality of the head voltage control.
Abnormality of the HDC substrate volt-
age.
The LED UV is not connected.
The machine received some data other
than command data.
• Securely connect the interface cable in
position.
• Use an interface cable conforming to the
specifications.
Any parameter outside the range of
acceptable numeric values was
received.
A maintenance command error
occurred.
To Next Page
Loading...
