2-12
5
Put the roll shaft with the media on the feeding device.
• Fitting the A part of the roll shaft to the B part bearing of the machine, put it on.
• Do not close the cover yet.
6
Fix the roll holder.
• The roll holders are at both of right and left. Fix both with the procedures below.
(1) While lifting the lever of the roll holder stopper, rotate it
to the position indicated in the figure.
(2) Get off of the lever once, and rotate it to the direction
indicated in the figure to tighten it.
(3) Repeat the Step (1) and (2) to lock the roll holder.
• Put the shaft on gently, not roughly.
To Next Page
Loading...
