2-18
When media thickness could not be detected
There may be a case where the media thickness cannot be detected properly depending on the media.
In such a case, the media thickness must be input manually.
1
An error is displayed, and the carriage returns to the
station.
2
Press to enter the media thickness (0.1 to
1.0mm).
3
Press the key.
• The media selection screen is displayed.
4
Press to select “ROLL” or “LEAF”.
• Detects the media width.
• Thickness detection is also performed here if the key is pressed at step 2 above.
To Next Page
Loading...
