2-22
3
Set the setting of the feeding unit to “OFF” in “Setting the feeding and take up” of
the machine setting. ( P.3-24)
4
Move the roll holder on the back of this machine.
• Loosen the roll holder fixing screw and then move it.
• Move the roll holder to the position where the media may be
right seen from the front of the machine.
5
Tighten the roll holder fixing screw.
• Check the Steps 2 to 3 again.
6
Set the left end of the core of the roll media on the
left roll holder.
• Push the roll media onto the roll holder until the roll core is
all the way seated.
7
Loosen the screw of the right roll holder, and
insert the holder into the paper core.
8
Raise the clamp lever in the rear side of this
machine.
To Next Page
Loading...
