2-23
1
2
Basic Operations
4
5
6
Setting a Media
9
Insert the roll media in this machine.
• The roll media can be smoothly inserted by slanting the media.
(1) Pull the media out of the roll to the head of the platen.
(2) Insert the media between the platen and the pinch roller.
• Pull the media out of the roll so that the media can be
grasped from the front of the machine.
(3) Push down the clamp lever from the back of this machine.
• The media is held.
10
Locking the roll stopper.
(1) Pull the roll stopper in the directionshown right.
(2) Press the lock pin to hold the roll stopper.
11
Pull out the roll media out.
(1) Open the front cover.
(2) Raise the clamp lever from the front of this machine.
(3) Pull out the roll media gently and then stop pulling when
locked lightly.
12
Push down the clamp lever from the front of this machine.
Check the position of the media edge surface and the feed roller.
• When you clamp the media edge surface
with the pinch roller and the feed roller, the
quality of transferring media may be
degraded. Before setting media, adjust the
position of the roll holder fixing the media.
To Next Page
Loading...
