Alarm and Prompt Messages Alarms and Messages
6 - 30 046-004667-00 A7™ Operating Instructions
Close manual valves prior to
disabling Backup Flow Control
This message displays when the needle valve is not closed and the
user presses the Ye s button to disable Backup Flow Control (if BFCS
is active).
Contact service to disable
Backup Flow Control
This message displays when the user presses the disabled Disable
Backup Flow Control button (if BFCS is active).
Close manual valves prior to
"End Case"
This message displays when the needle valve is not closed and the
user presses the End Case button (if BFCS is active).
Cannot set Fresh Gas Flow
in Monitor mode.
This message displays when the user presses the fresh gas flow area
or adjusts encoder knob in Monitor mode.
MESSAGE REMARK
TABLE 6-11 Prompt Messages Displayed in Pop-up Area
To Next Page
Loading...
Need help?
General
