Mindray A9 Service Manual

7-37
Message
Priority
Cause
Solution
05
malfunctions, or the
communication fails.
2. If the problem persists, disassemble the
VE component (refer to 8.29), and then
re-connect the cable of the AG module.
3. If the problem persists, replace the
internal AG module (refer to 11.1.7).
Internal AG Error
07
Low
Zeroing for the AG
module fails.
1. Restart the machine, and zero the AG
module again.
2. If the problem persists, disassemble the
VE component (refer to 8.29), and then
re-connect the cable of the AG module.
3. If the problem persists, replace the
internal AG module (refer to 11.1.7).
Internal AG Error
08
Low
Calibration for the AG
module fails.
1. Restart the machine, and calibrate the
AG module again.
2. If the problem persists, disassemble the
VE component (refer to 8.29), and then
re-connect the cable of the AG module.
3. If the problem persists, replace the
internal AG module (refer to 11.1.7).
Internal AG Error
09
Low
The substitute device of
the watertrap of the
internal AG module
loosens.
1. Restart the machine, and calibrate the
AG module again.
2. If the problem persists, disassemble the
VE component (refer to 8.29), and then
re-connect the AG module cable and the
watertrap adapter cable.
3. If the problem persists, replace the
internal AG module (refer to 11.1.7).
Internal AG Error
10
Low
The pump rate of the
AG module is below 20
mL/min for more than
1s.
1. Check whether the sampling line of the
AG module is bent or twisted.
2. Check whether the sampling line of the
AG module is occluded.
3. If the problem persists, replace the
filter.
4. If the problem persists, replace the AG
module (refer to 11.1.7).
Internal AG Error
11
Low
The substitute device of
the watertrap needs to be
replaced.
1. Restart the machine.
2. If the problem persists, disassemble the
VE component (refer to 8.29), and then
re-connect the AG module cable and the
watertrap adapter cable.
3. If the problem persists, replace the
internal AG module (refer to 11.1.7).
Internal AG Error
12
Low
The measured AG
module parameter
values exceed the
normal range.
1. Restart the machine, and calibrate the
AG module again.
2. If the problem persists, replace the
internal AG module (refer to 11.1.7).
7.3.12 BIS Module Runtime Alarms
Message
Priority
Cause
Solution
BIS Init Error High
The system fails to
receive information
1. Re-plug the BIS module, or replace
the slot.

Mindray A9 Specifications

General

Brand	Mindray
Model	A9
Category	Medical Equipment
Language	English