Reagents, Calibrators and Controls
CAUTION
Use appropriate reagents, calibrators and controls on the system.
Select appropriate reagents according to performance characteristic
of the system. Consult the reagent suppliers, Mindray or
Mindray-authorized distributor for details, if you are not sure about
your reagent choice.
Store and use reagents, calibrators and controls strictly as instructed
by the suppliers. Otherwise, you may not obtain reliable results or
best performance of the system.
Improper storage of reagents, calibrators and controls may lead to
unreliable results and bad performance of the system even in validity
period.
Perform a calibration after changing reagents. Otherwise, you may
not obtain reliable results.
Contamination caused by carryover among reagents may lead to
unreliable test results. Consult the reagent manufacturer or
distributor for details.
Backing up Data
NOTE
The system can automatically store data to the built-in hard disk of
the PC. However, data loss is still possible due to mis-deletion or
physical damage of the hard disk. Mindray recommends you to
regularly back up the data to portable storage device.
Computer and Printer
NOTE
Refer to the operation manuals of computer and printer for details.
External Equipment
WARNING
External equipment connected to the system, such as PC and printer,
shall be consistent with IEC 60950/EN 60950/ GB4943, EN55022
(Class B) /GB 9254 (Class B) and EN55024/ GB-T 17618.
To Next Page
Loading...
Need help?
General
