Mindray BS-130 - Page 176

8 Test and Maintenance Software 8-9
Figure 8-8 ISE Module
The following is the introduction of the sending instruction and the returning instruction.
 Handshake: shake hands with ISE module.Sending instruction: <ISE?>, returning
instruction <ISE!>
 Purge A: Purge A cleaning. Sending instruction: <PUGA>
 Purge B: Purge B cleaning. Sending instruction: <PUGB>
 Bubble calibration: Sending instruction <BBCL>, returning instruction <BBC A xxx M
xxx L xxx>
 Calibration: sending instruction <CALB>, returning instruction <CAL Li xx.xx Na xx.xx
K xx.xx Cl xx.xx eeeeeeec> <CAL Li xx.xx Na xx.xx K xx.xx Cl xx.xx eeeeeeec>
 Maintenance: Sending instruction: <MANT>, returning instruction <ISE!>
 Single step serum: Sending instruction: <SAMP>, returning instruction <ISE!>
 Single step urine 1: Sending instruction: <UWBW>, returning instruction <ISE!>
 Single step urine 2: Sending instruction: <UWBW>, returning instruction <ISE!>
 Single step wash: Sending instruction: <CLEN>, returning instruction <ISE!>
 Single step pump calibration: Sending instruction: <PMCL>, returning instruction
<ISE!>
 Single step start: Sending instruction: <STRT>, returning instruction /
 Dispense purge A: Sending instruction: <DSPA_200>, returning instruction <ISE!>