5-5
5.11 Set IP Address
If your ventilator needs to upgrade the software, follow these steps to set the IP address:
1. Push the Menu key. Select [Maintain] → [User] → enter the required password →
[Setup] → [IP Address].
2. Set the IP address. IP address has four step boxes. The setting range of each of the box is
0 to 255.
5.12 Manage Configurations
The ventilator provides the following types of configurations:
Factory configuration, namely, factory preset configuration. There are factory default
adult configuration and factory default pediatric configuration based on patient type.
User configuration. You can change the ventilator’s settings based on the actual
requirement and save the changed settings as user configuration. There are user adult
configuration and user pediatric configuration based on patient type.
Latest configuration. In actual applications, you may change some settings, which,
however, may not be saved as user configuration. The ventilator stores these settings in
real time. The stored settings are the latest configuration.
5.12.1 Restore the Latest Configuration Automatically
When the ventilator is used on a same patient after powered on, the system adopts the latest
configuration automatically.
5.12.2 Set Power-on Default Configuration
The ventilator can be set to loading factory default configuration or user default configuration
of different patient categories. When the ventilator is used on a new patient, the ventilator
loads the set default configuration automatically.
1. Push the Menu key. Select [Maintain] → [User] → enter the required password →
[Config].
2. Set [Select Default Config].
To Next Page
Loading...
Need help?
General
