Mindray SynoVent E5 - Save as User Configuration; Load Configuration Manually; View System Information; Version Information

5-6
5.12.3 Save as User Configuration
You can change the ventilator’s settings based on the actual requirement and save the
changed settings as user configuration.
1. Push the Menu key. Select [Maintain] → [User] → enter the required password →
[Config].
2. If the current patient type is adult, select [Save as User Adu Config]. If the current
patient type is pediatric, select [Save as User Ped Config].
5.12.4 Load Configuration Manually
You can load configuration when necessary during the operation of the ventilator.
1. Push the Standby key. The system enters standby status after your confirmation.
2. Push the Menu key. Select [System] and then [Load Config].
3. Select your desired configuration.
5.13 View System Information
5.13.1 Version Information
Push the Menu key. Select [Syst. Info] and then [Version s ]. You can view the version
information of system software.
5.13.2 Configuration Information
Push the Menu key. Select [Syst. Info.] and then [Config Info]. You can view the
configuration information of the ventilator such as ventilation mode.
5.13.3 System Check Results
Push the Menu key. Select [Syst. Info] and then [Syst. Check]. You can view the ventilator
system check information, including check items, check results, and check time.
5.13.4 Maintenance Information
Push the Menu key. Select [Syst. Info] and then [Maintain]. You can view total system
running time, system startup time, CO2 last calibration time, O2 sensor last calibration time,
and flow sensor last calibration time.