6-20
6. [Tslope]: Time of pressure rising
7. [ΔPapnea]: Pressure of apnea ventilation
8. [fapnea]: Frequency of apnea ventilation
9. [ATRC]: Automatic tube resistance compensation
In APRV under NIV, you need to set the following ventilation parameters:
1. [O2%]: Oxygen concentration
2. [Phigh]: High pressure
3. [Thigh]: Time of high pressure
4. [Plow]: Low pressure
5. [Tlow]: Time of low pressure
6. [Tslope]: Time of pressure rising
7. [ΔPapnea]: Pressure of apnea ventilation
8. [fapnea]: Frequency of apnea ventilation
6.8 Change Alarm Limits
You can change the alarm limits for Paw, MV, ftot and TVe by pushing the Alarm Setup key
and selecting [Alarm Limits]. You can change the alarm limits for EtCO2 if your ventilator
is configured with CO2 module. You can also change alarm volume and apnea time. For
details, refer to 9 Alarms.
6.9 Ventilate the Patient
WARNING
Before use on the patient, check that the oxygen concentration in the delivered gas
is consistent with the set value.
Select [Start Ventilation] when in Standby and the system begins to ventilate the patient
according to your settings.
To Next Page
Loading...
