129
A
DDITIONAL FEATURES PREFERRED LINE AND PREFERRED LINE TIMEOUT
NOTE:
1. If you specify a value of 0 for the Preferred Line parameter, it disables the preferred line focus feature.
2. If you specify a value of 0 for the Preferred Line Timeout parameter, the phone returns the line to
the preferred line immediately.
PHONE FEATURE PREFERRED LINE BEHAVIOR
Last Call Return The phone switches back to the focused line immediately after the
call ends.
Speeddial The line is already specified when the speed dial is created. The
phoneswitches back immediately after the call ends.
Conference For incoming calls, the phone switches back immediately after the
call ends.
Transfer For incoming or outgoing calls, the current behavior is that the same
line used to transfer the call does not change. For incoming calls,
the phone switches back immediately after the call transfers.
Park The phone switches back immediately after the call ends.
Voicemail The phone switches back immediately after the call ends.
Redial The phone switches back immediately after the call ends.
Dialing For incomplete dialing on a non-preferred line, the focus does not
change ifsome digits are entered.
If no digits are entered or digits were cleared, the focus changes to
preferredline after the time out has passed without activities.
Caller ID If the Switch UI Focus To Ringing Line parameter is disabled, the
User is able to see the Caller ID when the phone switches the focus
to the ringing line.
Factory Default Factory default and recovery mode clears the preferred line and
preferred line timeout parameters, and the phone operates in a
non-preferred line mode.
To Next Page
Loading...
