Mitel 6910 - Additional Features; Display Dtmf Digits

133
ADDITIONAL FEATURES DISPLAY DTMF DIGITS
ADDITIONAL FEATURES
This section describes additional features you can use on the 6910 phone.
DISPLAY DTMF DIGITS
A feature on the IP phones allows users to enable or disable DTMF (dual-tone multi-frequency) digits to
display to the IP phone when using the keypad to dial, or when dialing from a programmed key.
DTMF is the signal sent from the phone to the network that you generate when you press the phone’s
touch keys. This is also known as touch-tone dialing. Each key you press on your phone generates two
tones of specific frequencies. One tone is generated from a high-frequency group of tones and the other
from a low frequency group.
If you enable the Display DTMF Digits parameter, the digits you are dialing from the keypad or from a
programmable key display to the IP phone’s LCD display. This parameter is disabled by default (no digits
display when dialing).
You can enable the Display DTMF Digits parameter using the Mitel Web UI.