Mitel 6910 - Configuring Xml Beep Support; Status Scroll Delay

137
ADDITIONAL FEATURES STATUS SCROLL DELAY
CONFIGURING XML BEEP SUPPORT
MITEL WEB UI
1. Click on Basic Settings > Preferences > General.
2. XML Beep Support is enabled by default. If required, disable the XML Beep Support field by
unchecking the check box.
3. Click Save Settings.
STATUS SCROLL DELAY
Using the Mitel Web UI, you can specify a scroll delay option that allows you to set the time delay, in
seconds, between the scrolling of each status message on the phone. You can specify this setting in the
Status Scroll Delay (seconds) field at the path Basic Settings > Preferences > General. The default time
is 5 seconds for each message to display before scrolling to the next message. You can increase or
decrease this time as required. Setting and saving the value in the Mitel Web UI applies to the phone
immediately.