Mitsubishi Electric 3F-14C-WINE - Page 131

11-131 11-131
11.6.3.1. Auto indent with specific commands
Insert/align indent when there is a specific command line break in the command edit area. This function can be used
only when "11.6.3Auto indent" is valid.
Figure 11-1 Auto indent with specific commands
The instructions for automatic indentation are as follows.
Combination of corresponding instructions
Indent of insert
If
For
Function
Select
While
Indent of align
*1
ElseIf
Else
EndIf
Next
FEnd
End Select
WEnd
*1The indentation is aligned with the start position of the commands.
Insert indent
Align indent
Click Enter
The beginning position of the
For and Next statement are the
same position
Click Enter
Insert indent for the number of characters
specified in "11.6.3.2Number of indent
characters"