11-183 11-183
11.13.2. Copy
This copies program files. Copying of the entire program file or only the command statements or only the position
variables are possible.
Select the transmission source program names from the list at the left, and designate the transmission
destination folder on the right side. Multiple transmission source programs can be selected at the same time, but
only one program must be selected when copying with a name change. Copying is executed when the [Copy]
button is clicked and [Setting for copy] dialog is set.
Figure 11-81 Copy Setting Screen
It is possible to copy by using the project tree.
Figure 11-82 Copying the program by using the project tree
A program set with “Read protection” can only be copied to the identical controller.
To Next Page
Loading...
