23-619 23-619
23.4. Starting I/O Simulator
Before starting the I/O simulator, create an I/O simulator definition file.
For an explanation of creating an I/O simulator definition file, refer to “23.2 Simulator settings”.
To start up the I/O simulator, click the [Online] tab -> [I/O Simulator] group [Start] button on the ribbon in the
simulation mode.
Figure 23-10 Starting I/O simulator
Click the [Start I/O simulator] button to display the following [I/O simulator start] screen.
Figure 23-11 I/O simulator start screen
Click the [Browse] button to select an I/O simulator definition file. The file used in the simulation can be checked
on the [Simulator setting] screen.
I/O simulator start, and the character “I/O Simulator” is displayed on the status bar. The letters [GX Simulator]
also are displayed when the controller is connected to either GX Simulator2 or GX Simulator3.
Figure 23-12 Status bar during I/O simulator operating
When connected to GX Simulator2/3
To Next Page
Loading...
