Mitsubishi Electric 3F-14C-WINE - Operating Environment; Connectable Robot Controllers

1-21 1-21
1.4. Operating Environment
This explains the operating environment.
1.4.1. Connectable robot controllers
This software can connect to the robot controllers shown below
Table 1-3 Connectable Robot Controllers and Communications Types
Robot controller
Communications (*1)
Remark
CR800-D/CR750-D/
CRnD-700 series
(The photo is the robot
controller for CR800-D.)
USB (*2)
Commercial items such as computers and
cables might be incompatible with our equipment
or the FA environment such as temperature and
the noise, etc.
When using, please confirm the operation
enough, because you might have to take
measures against noise such as EMI measure or
addition of ferrite core.
Ethernet (TCP/IP)
RS-232
Only CRnD-700 series
GOT communications
Communicate with CR800-D/CR750-D/
CRnD-700
series controller connected with the
GOT via Ethernet by USB / RS-232.
GOT 2000/
1000 series and the Ethernet
communication unit (GT25-J71E71-100/
GT15-J1E71-100) are needed.
CR800-R/CR800-Q/
CR750-Q/CRnQ-700 series
(The photo is the robot
controller for CR800-R.)
CRnQ_R
communications
USB (*2)
Ethernet
(TCP/IP)
The PLC RCPU, Ethernet interface module or
Built-in Ethernet port QCPU is required.
RS-232
Ethernet (TCP/IP)
Only can be used for CR800-R/CR800-Q
CRn-500 series
Ethernet (TCP/IP)
The robot controller must have the "Ethernet
interface" option.
RS-232
(*1) The computer must have the respective communication ports.
(*2) When using a USB connection, 1 computer can connect to only 1 robot controller.
This software can be connected to a maximum of 32 controllers at the same time. These controllers may be different
models.